Mit der Puls-air Heizung 50 % save heating costs
50 % of heating cost savings
Menu
Mit der Puls-air Heizung 50 % save heating costs
50 % of heating cost savings
"Heating oil consumption more than halved"
Riggisberg/Switzerland. A total of 3 appliances can be found on Walter Keusen's premises in Riggisberg. Among other things, an old workshop, a new workshop and a training room are each heated with a Puls-air heater from South Tyrol.
Mr. Keusen can easily compare the economy and effectiveness of Puls-air, as he previously used an oil-fired central heating system and ceiling fans. The heating oil consumption was more than twice as high and the heat was not well distributed in the room. Now all 3 halls/rooms are quickly and evenly warm with low heating costs, quiet running noise and odorless operation.
Puls-air is no ordinary oil heater. It uses patented pulsating combustion, which provides enormous heat with low oil consumption. Due to its compact design, people often don't believe it, but a Puls-air heater can heat rooms of up to 2,000 cubic meters (with good insulation). Larger halls can easily be equipped with 2 or more units.
The built-in patented pulsating combustion is not a "direct current combustion", but an "alternating current combustion".
This means that the fresh gas column (fuel and air) and the flue gas column in the combustion chamber meet 62 times per second. When they meet, many small reactions occur which generate heat. Each reaction also produces a pressure wave, accompanied by a sound wave, which must be added to the efficiency. The efficiency is at least 97 %.
Puls-air is physically positioned correctly on the floor of the room to be heated - this allows the warm air to be distributed below where work is being carried out, then slowly rises, cools down again at the top, sinks again and is preheated by the fan on the appliance and repeatedly drawn past the burner. This creates a thermal air roll that heats the entire room evenly and significantly reduces heating costs.
Puls-air is so compact that it is delivered on a Euro pallet. Dimensions approx. 75 x 5 5x 95 at 75 kg. The exhaust gas is routed outside via the roof using a 35 mm stainless steel pipe. No separate chimney is required! The manufacturer recommends connecting the appliance to a larger heating oil tank.
The Puls-air team will advise you by phone, email or WhatsApp on which heater is right for you and answer all your questions.
There are 2 models of Puls-air. Puls-air Standard up to 600 m³ and Puls-air Plus up to 1,800 m³. Both values with very good insulation. For larger rooms, several devices can also be used in combination.
With conventional ceiling fans, a lot of heat is lost through long pipes. Heating large quantities of water in the boiler also requires a lot of energy. In addition, conventional oil burners have poor efficiency. With Puls-air, the efficiency is 97 %, which means that almost all the fuel that is introduced is converted into heat. In addition, Puls-air stands on the floor of the room to be heated, releases the warm air where it is being used and creates a slowly rotating thermal air roll in the room. The air is not always heated from 0, but is drawn through the heater again and again, preheated.
GF Schinagl also notices positively that the running noise of Puls-air is much more pleasant and that much less dust is whirled up than with the ceiling fans.
BAVARIAN STATE PRIZE FOR SPECIAL TECHNICAL ACHIEVEMENTS IN THE SKILLED CRAFTS SECTOR
AUSTRIAN STATE PRIZE FOR ENERGY RESEARCH AND THE ENVIRONMENT
Request information material:
Operating instructions, folder, data sheet in German, English and Dutch.
Imprint | AGB & Data protection | Order form as PDF | Online order | Contact us | Operating instructions | Operating instructions
Puls-air heaters | Innsbruckerstraße 10 | A-6353 Going am Wilden Kaiser
Contact: 0043 5358 3600 | info@pulsair.net
Contact AUT: 0043 6642015883 | austria@pulsair.net
Puls-air heaters
Innsbruckerstrasse 10
A-6353 Going am Wilden Kaiser
Contact:
Contact AUT:
Left:
