With the Puls-air heater 50 % save heating costs

50 % of heating cost savings

Customer reference

Fahrzeugtechnik Raab Langenleiten Germany

Text follows!

Initial situation - inefficient interim solution

Before Puls-air was installed, the workshop was heated with radiators and electric fans. This solution proved to be cost-intensive and inefficient.
The annual heating costs were around CHF 6,000, with limited heat output and slow heating.

The decision for Puls-air

The company became aware of Puls-air through a combination of trade journals, internet research and recommendations from other garages.
Particularly decisive for the purchase decision were:
- Positive experience reports from other companies
- Recommendations from the field
- The prospect of lower operating costs with better heating performance
Puls-air has been successfully in operation since fall 2025.

Significantly better performance in everyday life

The new heating solution offers noticeable improvements in daily use:
- Faster heating of the workshop
- Significantly better heat output
- Even heat distribution in the room (very good)
- Thermostat operation: 18 °C during working hours (7:30 - 17:00)
Overall, employees rate the system as "highly satisfied".

Focus on economic efficiency

A decisive advantage can be seen in the running costs:
- Before: approx. CHF 6,000 per year
- Now: approx. CHF 3,500 per year
This results in significant cost savings combined with greater comfort and better heating performance.

The advantages at a glance
- Fast and efficient heat
- Lower heating costs
- Even heat distribution
- Simple and reliable use in everyday work

Conclusion

With Puls-air, TMS Automobile GmbH has found a heating solution that is both economically and technically convincing.
The combination of fast heating, lower costs and high efficiency makes the system the ideal solution for modern workshops.
"Warmer faster, better heat, lower costs."

The right heating for all workshops and halls

There are 2 models of Puls-air. Puls-air Standard up to 600 m³ and Puls-air Plus up to 1,800 m³. Both values with very good insulation. For larger rooms, several devices can also be used in combination.

Why is pulse air so much more economical?

With conventional ceiling fans, a lot of heat is lost through long pipes. Heating large quantities of water in the boiler also requires a lot of energy. In addition, conventional oil burners have poor efficiency. With Puls-air, the efficiency is 97 %, which means that almost all the fuel that is introduced is converted into heat. In addition, Puls-air stands on the floor of the room to be heated, releases the warm air where it is being used and creates a slowly rotating thermal air roll in the room. The air is not always heated from 0, but is drawn through the heater again and again, preheated.

Running noise and dust exposure

GF Schinagl also notices positively that the running noise of Puls-air is much more pleasant and that much less dust is whirled up than with the ceiling fans.

Further references:

en_US