Mit der Puls-air Heizung 50 % save heating costs

50 % of heating cost savings

Customer reference

"We should have bought Puls-air 10 years ago"

No more high heating costs and cold feet at work

At the Langschlag car dealership in the Zwettl district of Lower Austria, the 1,500 m³ workshop has been heated with the Puls-air workshop and hall heating system from Tyrol since 2023.

Why is Puls-air so economical?

Managing Director Manuel Eßmeister mentions in an interview with Puls-air that he should have switched to Puls-air 10 years ago. The heating costs before were enormous and have been significantly reduced by Puls-air, so that the investment has quickly paid off. The pulsating combustion installed is not "direct current combustion", but "alternating current combustion".

This means that the fresh gas column (fuel and air) and the exhaust gas column in the combustion chamber collide 62 times per second, which leads to many individual, additional, small explosions that generate heat. (oscillating gas column) Each small explosion also generates a pressure wave, accompanied by a sound wave, which must be added to the efficiency. The efficiency is at least 97 %.

The fuel molecules are torn open down to the atomic level. The "skin", consisting of combustion products, is destroyed. No soot is produced during combustion, maintenance costs are close to zero and the exhaust gas values (NOX - 25 - 30, CO - 2 - 5 ppm; soot number 00) speak for themselves.

Simple commissioning (plug and play)

The heater is so compact that it is delivered on a Euro pallet. Dimensions approx. 75 x 55 x 95 cm at 75 kg. For commissioning, the heater must be placed on the floor of the room to be heated. The exhaust gas is routed outside via the roof using a 35 mm stainless steel pipe. The manufacturer recommends connecting the appliance to a larger tank. Overall, Puls-air is very easy to put into operation and no separate chimney is required, just the 35 mm stainless steel pipe. At the Langschlag car dealership, it was even less work, as the exhaust gas could be fed into an existing chimney.

Clean and efficient

Puls-air has been on the market since 1984 and was developed by Georg Pletzer, who at the time was working intensively on engines and, in particular, the pulse engine. During his research, he noticed that pulsating combustion generates enormous heat with very low fuel consumption and excellent exhaust values. As a man of action, he began to use his findings to develop a heater that makes other heaters look cold in terms of consumption and efficiency. Puls-air is now in its 3rd generation, and the enthusiasm continues to grow.

50 % less heating costs

Thanks to the efficiency of 97 % just mentioned, workshops and hall owners save a lot of heating oil and therefore money. Most Puls-air owners surveyed by Puls-air were able to more than halve their heating costs.

State prize awarded

Puls-air was awarded the Austrian State Prize for Energy Research and the Environment and the Bavarian State Prize for Special Technical Achievements in Craftsmanship.

Heat where people work.

Low costs are important, but it is at least as important that the hall/workshop is warm. Because Puls-air is placed on the floor of the room to be heated and the warm air is released near the floor, it is distributed where work is being carried out. As the warm air is lighter, it rises slowly at some point, cools down again at the top, sinks and is drawn back through the device preheated. This creates a slowly rotating thermal air roll which heats the room evenly and saves heating costs. Mr. Eßmeister mentions that his workshop is warm within 10-20 minutes, even on cold winter days.

Personal advice

The Puls-air team will advise you by phone, email or WhatsApp on which heater is right for you and answer all your questions.

The right heating for all workshops and halls

There are 2 models of Puls-air. Puls-air Standard up to 600 m³ and Puls-air Plus up to 1,800 m³. Both values with very good insulation. For larger rooms, several devices can also be used in combination.

Why is pulse air so much more economical?

With conventional ceiling fans, a lot of heat is lost through long pipes. Heating large quantities of water in the boiler also requires a lot of energy. In addition, conventional oil burners have poor efficiency. With Puls-air, the efficiency is 97 %, which means that almost all the fuel that is introduced is converted into heat. In addition, Puls-air stands on the floor of the room to be heated, releases the warm air where it is being used and creates a slowly rotating thermal air roll in the room. The air is not always heated from 0, but is drawn through the heater again and again, preheated.

Running noise and dust exposure

GF Schinagl also notices positively that the running noise of Puls-air is much more pleasant and that much less dust is whirled up than with the ceiling fans.

From around 130 € per month get
Finally get a grip on your heating costs!

You can either buy or lease your Puls-air workshop heater at a favorable price.
It has never been so easy to heat your workshop cheaply*.

*Without down payment, residual value 10% of the purchase value (AW) plus VAT, term 48 months, for Germany only. Leasing offer via our partner MMV Leasing GmbH, subject to credit check, etc. There are no additional costs. The stated leasing rate is the net rate (plus 19% VAT for Germany). MMV Leasing carries out a contract acceptance check before concluding the contract. 2 Warranty extension and steering wheels cannot be leased and may have to be ordered separately. The freight costs will not be charged again.

Further references:

en_US
Nachricht senden!
Schönen Tag! 👋
Gerne beraten wir Sie von Mo-Fr von 08:00 - 17:00 Uhr bequem per Whatsapp!